《位移位存储总线寄存器CD4094中文资料》由会员分享，可在线阅读，更多相关《位移位存储总线寄存器CD4094中文资料（28页珍藏版）》请在装配图网上搜索。
1、位移位存储总线寄存器CD4094中文资料CD4094是带输出锁存和三态控制的串入/并出高速转换器，具有使用简单、功耗低、驱动能力强和控制灵活等优点。CD4094的引脚图及引脚描述其中(1)脚为锁存端，(2)脚为串行数据输入端，(3)脚为串行时钟端。(1)脚为高电平时，8位并行输出口Q1Q8在时钟的上升沿随串行输入而变化；(1)脚为低电平时，输出锁定。利用锁存端可方便地进行片选和级联输出控制。(15)脚为并行输出状态控制端，(15)脚为低电平时，并行输出端处在高阻状态，在用CD4094作显示输出时，可使显示数码闪烁。(9)脚QS、(10)脚QS是串行数据输出端，用于级联。QS端在第9个串行时钟的
2、上升沿开始输出，QS端在第9个串行时钟的下降沿开始输出。当CD4094电源为5V时，输出电流大于32MA，灌电流为1 MA。串行时钟频率可达25MHZ。 CD4094引脚图CD4094真值表：ClockOutput EnableStrobeDataParallel Outputs 并行输出Serial Outputs 串行输出Q1QNQS (Note 1)Q S0XX三态三态Q7不变0XX三态三态不变Q710X不变不变Q7不变1100QN-1Q7不变1111QN-1Q7不变111不变不变不变Q7CD4094内部电路方框图Absolute Maximum Ratings 绝对最大额定值：Supp
3、ly Voltage电源电压(VDD)-0.5 To +18 VDCInput Voltage输入电压 (VIN)-0.5 To VDD +0.5 VDCStorage Temperature Range储存温度范围 (TS)-65 To +150Power Dissipation功耗 (PD)Dual-In-Line 普通双列封装700 MWSmall Outline 小外形封装500 MWLead Temperature 焊接温度(TL)Soldering, 10 Seconds)（焊接10秒）260Recommended Operating Conditions 建议操作条件：DC Su
4、pply Voltage 直流供电电压 (VDD)+3.0 To +15 VDCInput Voltage输入电压 (VIN)0 To VDD VDCOperating Temperature Range工作温度范围 (TA)-40 To +85DC Electrical Characteristics 直流电气特性：Symbol符号Parameter参数Conditions 条件-40C+25C+85CUnits 单位最小最大最小典型最大最小最大IDDQuiescent Device Current静态电流VDD = 5.0V2020150AVDD = 10V4040300VDD = 15V
5、8080600VOLLOW Level Output Voltage 输出低电平电压VDD=5.0V|IO|1.A0.0500.050.05VVDD=10V0.0500.050.05VDD=15V0.0500.050.05VOHHIGH Level Output Voltage 输出高电平电压VDD=5.0V|IO|1A4.954.955.04.95VVDD=10V9.959.9510.09.95VDD=15V14.9514.9515.014.95VILLOW Level Input Voltage 输入低电平电压VDD = 5.0V, VO = 0.5V Or 4.5V1.51.51.5VV
6、DD = 10V, VO = 1.0V Or 9.0V3.03.03.0VDD = 15V, VO = 1.5V Or 13.5V4.04.04.0VIHHIGH Level Input Voltage 输入高电平电压VDD = 5.0V, VO = 0.5V Or 4.5V3.53.53.5VVDD = 10V, VO = 1.0V Or 9.0V7.07.07.0VDD = 15V, VO = 1.5V Or 13.5V11.011.011.0IOLLOW Level Output Current 输出低电平电流 (Note 4)VDD=5.0V,VO=0.4V0.520.440.880.
7、36MAVDD=10V,VO=0.5V1.31.12.250.9VDD=15V,VO=1.5V3.63.08.82.4IOHHIGH Level Output Current 输出高电平电流 (Note 4)VDD=5.0V,VO =4.6V-0.52-0.440.88-0.36MAVDD =10V,VO= 9.5V-1.3-1.12.25-0.9VDD=15V,VO =13.5V-3.6-3.08.8-2.4IINInput Current 输入电流VDD =15V,VIN =0V-0.3-0.3-1.0AVDD=15V,VIN =15V0.30.31.0IOZ3-STATE Output
8、Leakage Current 3态输出漏电流VDD=15V,VIN=0V Or 15V1110AAC Electrical Characteristics 交流电气特性：Symbol 符号Parameter 参数Conditions 条件最小典型最大Units 单位TPHL, TPLHPropagation Delay Clock To QSVDD = 5.0V300600NsVDD = 10V125250VDD = 15V95190TPHL, TPLHPropagation Delay Clock To Q SVDD = 5.0V230460NsVDD = 10V110220VDD = 1
9、5V75150NsTPHL, TPLHPropagation Delay Clock To Parallel OutVDD = 5.0V420840NsVDD = 10V195390VDD = 15V135270TPHL, TPLHPropagation Delay Strobe To Parallel OutVDD = 5.0V290580NsVDD = 10V145290VDD = 15V100200TPHZPropagation Delay HIGH Level To HIGH ImpedanceVDD = 5.0V140280NsVDD = 10V75150VDD = 15V55110
10、TPLZPropagation Delay LOW Level To HIGH ImpedanceVDD = 5.0V140280NsVDD = 10V75150VDD = 15V55110TPZHPropagation Delay HIGH Impedance To HIGH LevelVDD = 5.0V140280NsVDD = 10V75150VDD = 15V55110TPZLPropagation Delay HIGH Impedance To LOW LevelVDD = 5.0V140280NsVDD = 10V75150VDD = 15V55110TTHL, TTLHTran
11、sition Time过渡时间VDD = 5.0V100200NsVDD = 10V50100VDD = 15V4080TSUSet-Up Time Data To Clock 建立时间数据时钟VDD = 5.0V8040NsVDD = 10V4020VDD = 15V2010Tr, TfMaximum Clock Rise And Fall Time最大时钟上升和下降时间VDD = 5.0V1MsVDD = 10V1VDD = 15V1TPCMinimum Clock Pulse Width最小时钟脉冲宽度VDD = 5.0V200100NsVDD = 10V10050VDD = 15V8340TPSMinimum Strobe Pulse WidthVDD = 5.0V200100Ns VDD = 10V8040VDD = 15V7035FmaxMaximum Clock Frequency 最大时钟频率VDD = 5.0V1.53.0MHzVDD = 10V3.06.0VDD = 15V4.08.0CINInput Capacitance 输入电容Any Input5.07.5PF 测试电路和3态时序图 时序图
位移位存储总线寄存器CD4094中文资料
