LIR2032承认书(中英文)

《LIR2032承认书(中英文)》由会员分享，可在线阅读，更多相关《LIR2032承认书(中英文)（12页珍藏版）》请在装配图网上搜索。

1、市达立科技可充电锂离子扣式电池Lithium-ion Rechargeable Cell Battery产品编号Model No.: LIR2032承认书Specs Approval客户名称: 供货商: Name of Customer : Name of Supplier:市达立科技销售中心：市宝安区宝源华丰总部经济大厦1608-1609TEL：06FAX：06: czyan888163.生产工厂地址：j金坛市茅麓镇西阳村Specification for Magnetic TransducerPage（页）2/11Model No（型号）.: LIR2032CONTENTS适用围 Appl

2、icable Scope产品类型 Type of Products3.主要特点 General Features4.规格特性表 Spec Chart5.电池特性Battery Characteristics6.须知 Important NotesSpecification for Magnetic TransducerPage（页）3/11Model No（型号）.: LIR2032适用围 Applicable Scope本承认书适用于比佳原电池生产的锂离子充电电池。This specs approval is applied only for the lithium-ion recharge

3、able cell battery produced by Bigard.产品类型 Type of Products种类: 扣式锂离子充电电池 Type : Lithium-ion rechargeable cell battery型号: LIR2032 Model : LIR20323.主要特点 General Features使用寿命长 Long Cycle Life正常使用条件下，可循环使用充放电周期500周，容量70%。Under normal usage, the cycle life of the battery can be 500 circles while with capa

4、city 70%比能量大 High Power Density高能量密度，使电池重量轻、体积小，更使用于小型用电设备。High power density makes the battery light in weight and small in dimension. It can be used in small devices.使用安全可靠 Safe and Reliable没有游离的金属锂，电池使用更安全。 No floating metal lithium assures a safer usage.工作电压高 High working voltage工作电压高达3.6V，大约是镍镉

5、或镍氢电池的3倍，可减小电池的使用数量。Working voltage is up to 3.6V, approx. 3 times of the voltage of NI-MH or NI-CD, which reduces the quantity of the battery needed in certain application.无记忆效应 No memory effect无记忆效应，使其无时不为你提供最大的能量。No memory effect assures a constant maximum application.自放电率小7%/月。 Low self-discharg

6、e rate : 7%/month一致性好 Good Consistency公司部按ISO9000标准建立质量保证体系，对生产全过程实行严格控制，使电池容量、阻、放电平台、荷电保持能力等性能保持良好的一致性。Good consistency is showed in battery capacity, internal resistance, discharge platform and capacity retention. A strict complete internal quality control is subject to the ISO9000 system in the c

7、ompanys production.Specification for Magnetic TransducerPage（页）4/11Model No（型号）.: LIR20324.规格特性表 Spec Chart20.0mm -0.23.2mm +0.35最高容量（mAh）内阻（m）直径（mm）20.0 -0.23.2 +0.35高度（mm）尺寸2.80.3重量Weight（g）40600Standard features项目 ItemLIR2032型号 Model35标称容量（mAh）3.6额定电压（V）阻值检测标准：以0.2CmA恒流充电，当电池端电压达到充电限制电压4.20V后，转为恒

8、压充电，当电流值小于0.05CmA时终止充电并搁置1小时后，用1000Hz阻仪器进行检测。Internal resistance test standard:CC charge 0.2CmA / voltage up to 4.20V; Then CV charge.Terminate charging when the charging current value is less than 0.05CmA.Rest for 60 minutes, then test the battery by 1000Hz internal resistance tester.5. 电池特性Battery

9、 Characteristics5.1测试条件 Test ConditionsTemperature温度：201Relative Humidity: 相对湿度：755Atmosphere pressure大气压力：1atm5.2标准充放电特性 Standard Charge/Discharge Characteristics在上述条件下测试：The test should be conducted under the condition below:在环境温度205的条件下，以0.2CmA恒流充电，当电池端电压达到充电限制电压4.20V后，转为恒压充电，当电流值小于0.05CmA时终止充电并放

10、置不超过10分钟，再以0.2CmA电流恒流放电到2.75V。In a temperature of 205, CC charge 0.2CmA / voltage up to 4.20V; Then CV charge.Terminate charging when the charging current value is less than 0.05CmA.Rest for no more than 10 minutes,Discharge CC at 0.2CmA to 2.75V.5.3快速充放电特性：在环境温度205的条件下，以1CmA恒流充电，当电池端电压达到充电限制电压4.20V

11、时，改为恒压充电，直到充电电流小于0.05CmA，停止充电并放置不超过10分钟，再以1CmA电流恒流放电到2.75V。Fast Charge/Discharge : Temperature 205, CC charge at 1.0CmA to 4.20V; turn to CV charge; Terminate charging when the charging current value is less than 0.05CmA, rest for no more than10 minutes, then at 1CmA CC discharge to 2.75V.5.4工作温度特性：

12、工作温度围：2060。Temperature Characteristics : Working temperature range: 2060。Specification for Magnetic TransducerPage（页）5/11Model No（型号）.: LIR2032充放电曲线请参阅图1和图2；For charging/discharging characteristics at various currents see fig 1 or 2.不同温度放电曲线请参阅图3；For discharging characteristics at various temperatur

13、es see fig 3 or 4.自放电曲线请参阅图4；For Storage characteristics see fig 4.循环寿命曲线请参阅图5。For cycle life characteristics see fig 5.Specification for Magnetic TransducerPage（页）6/11Model No（型号）.: LIR2032图1. 不同电流条件下的充电特性Fig.1 Charging Characteristics at various currentsSpecification for Magnetic TransducerPage（页）

14、7/11Model No（型号）.: LIR2032图2. 不同电流条件下的放电特性Fig. 2 Discharge Characteristics at various currentsSpecification for Magnetic TransducerPage（页）8/11Model No（型号）.: LIR2032图3. 不同温度条件下的放电特性Fig. 3 Discharging Characteristics at various TemperaturesSpecification for Magnetic TransducerPage（页）9/11Model No（型号）.:

15、 LIR2032图4. 自放电保持特性Fig. 4 Storage CharacteristicsSpecification for Magnetic TransducerPage（页）10/11Model No（型号）.: LIR2032图5. 循环寿命曲线Fig. 5 Cycle Life ChartSpecification for Magnetic TransducerPage（页）11/11Model No（型号）.: LIR20326.须知 Important Notes远离热源、火源；Keep away from source of fire and/or heat.不要擅自解剖

16、电池或电池组；Do not disassemble battery and/or battery pack.不要将电池的正负极用金属片连接，也不要将电池与能够引起其短路的物品一起混放；Do not connect the positive and negative pole directly using conductive metal; avoid short circuit.不要将电池投入水中或弄湿； Do not put the battery into water or damp it.不得抛电池；Do not cut the battery.不得针刺、打击电池；Do not stri

17、ke or needle the battery.用专用的充电器进行充电；Charge the battery using specified chargers.不要用锡焊直接焊接引线与电池连接；Do not solder the battery directly.不要反接电池的正负极；Observe the correct polarity (+/-)不要将电池用于未指定的应用领域；Do not use the battery in un-specified application.不得将电池与干电池或其它类型电池混用；Do not mix the battery in usage with

18、 other types of battery.使用电池前应该仔细阅读使用说明书. Read the instruction manual carefully before use.加载产品使用时，建议设计充放电保护电路When the battery is used on load, it is recommended to design a charge/discharge protection circuit for the battery.在常温环境下，如电池储存三个月未使用要求对电池组织维护，维护方法：以0.2CmA电流恒流放电到2.75V，搁置5min后，以0.2CmA恒流充电，当

19、电池端电压达到充电限制电压4.20V后，转为恒压充电，当电流值小于0.05CmA时终止充电When the battery is stored and not used under room temperature for over 3 months, it needs to be recharged by the procedure below: Discharge by CC mode at 0.2CmA to 2.75V, then rest for 5 minutes，Charge by CC mode at 0.2CmA to 4.20V limit, then change to CV charge mode,Cut off the charge when the charging current is less than 0.05CmA.电池保质期为一年Quality Warrant : one year.11 / 12